Need Corny Kegs?

[Matt F]

Thanks Jeremy, if that's cool with you I would like to take the keg. Gets me up to 9 (well 7 that work, two really need some work). Thanks again. I will bring some cash to the next meeting or we can meet another time to exchange.

[-MG-]

I'll bring them with me to the meeting and leave them in the car. They'll be dirty and I haven't really looked at all of them closely

That will leave me with 7 total and 2 sanke's. I'm planning on following a guide to ferment under pressure with the sanke's and may start collecting more of those as time goes on. Just need to put together the spunding valve and get me a keg tap or two. Anyone have a good source for that? I suppose one can disassemble the pump portion that most stores have on their taps, but want to buy it online if i can.

[JimF]

MG, I've got a couple of Sanke connectors if that is what you are looking for. I can't make it to the meeting this month but you can swing by and pick them up or we can meet somewhere.

[Matt F]

If you ever decide to use your sanke's for serving, you can get couplers at Rapids. I have one and it works well. It was just a little over $20.

http://rapidswholesale.com/beer/couplers.html

[-MG-]

If you ever decide to use your sanke's for serving, you can get couplers at Rapids. I have one and it works well. It was just a little over $20.

http://rapidswholesale.com/beer/couplers.html

That's pretty much what I need to setup the system for pressure fermentation! Thanks for the heads up.

[-MG-]

Just an FYI to those who bought kegs.

I cleaned most of the ones I had, and tested them out with some pressure and cleaned all of the lines. Didn't have to take a part any of the fittings or anything.

A little oxyclean and a brush took care of the mud on the outside.

Hope everyone has the same experience!

[Gjoseph]

Yeah I drank to much and forgot to see if you had any extras