Cedar Rapids Brewing Society

Posted: **Thu Sep 11, 2014 6:41 am**

andrewmaixner wrote:
czubak wrote:I have no idea if it's flashable it was bought off amazon.

I can dig it all out of the drawer and bring it to this months meeting for ya. I am in Marion over by Linn Grove if that is near you. You are welcome to come get it if you want it sooner.
Meeting works, I have other things I have to build first.
Here's info on flashable/not:
http://www.blackboxbrew.com/diy/
To determine the version of controller you have, open the controller as shown in the video above at about 2:47. Once you have the board visible, look at the location highlighted below; if the board says A400_P, Version: 1.0 you have the correct board and can flash. If it says something else (the most common "bad" board says S1000-Power_V1.1), there is not currently a way to flash it.

I will try to remember to dig into it tonight. I need to check this board while I am at home rather than in the morning when I get to work

Posted: **Fri Sep 12, 2014 7:22 pm**

The one I have can be flashed. Sorry for the delay in checking it

Posted: **Wed Sep 24, 2014 9:03 am**

czubak wrote:The one I have can be flashed. Sorry for the delay in checking it

Well I missed the pre-order email yet again, which filled up in like an hour. They claim they will have a few hundred non-pre-ordered units available mid-october, but who knows.

I need to set up a time to drop by your place and pick that up, or meet up at the brewfest if the baby hasn't come yet.

Cedar Rapids Brewing Society

Looking for used equipment: kettle/BIAB, keezer parts, 22oz

Re: Looking for used equipment: kettle/BIAB, keezer parts, 2

Re: Looking for used equipment: kettle/BIAB, keezer parts, 2

Re: Looking for used equipment: kettle/BIAB, keezer parts, 2