Single Tier Brew Stand FS

[czubak]

Considering selling my stand with 3 BG14 burners, low pressure orifice valve, gas plumbing, valves, Brewers Harware wind screens, Fisher low pressure regulator. Hook up a propane tank and you are off and running. Painted with high temp paint and some bedliner on the lower areas out of the heat. There are 2 1/4" studs on the end to hang my maltmill from for milling.

No pumps or pots included. Pump mounts are there and will remain. I planned this stand to work up to 20 gallon kettles. Unsure if 10's would be wide enough. The openings are 12"x12" IIRC I attached a drawing of what I drew/built.

I have brewed 60 gallons through this system since mid March of this year and it works great. All 2" 14ga tubing. 24" tall with castors, 56" wide, 16" deep. I am eyeballing a blichmann top tier so this has to go to fund it.

$550 obo to beer nuts

[brownbeard]

I pitched it to the wife. No sale. Let me know if this sucker is still around in January.

[czubak]

Sold the entire setup, keggles and all. It's headed to Alaska.

I'd be happy to build another and I have my cut sheet and costs for everything. I had a friend weld it up. That's the only cost adder for an outsider. It was a fun build and a great setup, I just went back to a cooler, burner, kettle. To save space in the garage and recoup my investment.

I'm also doing smaller ~2 gallon BIAB batches inside to experiment and keep a bottle inventory over just legs.


Sent from my iPhone using Tapatalk