WANTED: 3/4" to 1/2" Stainless Steel Reducing Coupling

[Matt F]

Anybody have one of these I could buy from you? Otherwise going to order soon to use on the new pump head I got from Andrew.

http://www.bargainfittings.com/index.ph ... uct_id=127

[czubak]

I have a couple you can have Matt. I even have a 3/4" fitting with a male camlock on the end for this very purpose. Camlocks, rule....you should switch to camlocks

When do you need the fitting by? I can get it to you tomorrow or Friday if you want to meet for lunch. Easier than after work with all the flooding BS.

[Matt F]

Thanks Chris. No way I am switching from my old reliable cheap plastic Kent QDs until I go full tri-clamp. Boil kettle is already there. Camlocks are nice though.