Cedar Rapids Brewing Society

Considering selling my stand with 3 BG14 burners, low pressure orifice valve, gas plumbing, valves, Brewers Harware wind screens, Fisher low pressure regulator. Hook up a propane tank and you are off and running. Painted with high temp paint and some bedliner on the lower areas out of the heat. There are 2 1/4" studs on the end to hang my maltmill from for milling.

No pumps or pots included. Pump mounts are there and will remain. I planned this stand to work up to 20 gallon kettles. Unsure if 10's would be wide enough. The openings are 12"x12" IIRC I attached a drawing of what I drew/built.

I have brewed 60 gallons through this system since mid March of this year and it works great. All 2" 14ga tubing. 24" tall with castors, 56" wide, 16" deep. I am eyeballing a blichmann top tier so this has to go to fund it.

$550 obo to beer nuts

I pitched it to the wife. No sale. Let me know if this sucker is still around in January.

Sold the entire setup, keggles and all. It's headed to Alaska.

I'd be happy to build another and I have my cut sheet and costs for everything. I had a friend weld it up. That's the only cost adder for an outsider. It was a fun build and a great setup, I just went back to a cooler, burner, kettle. To save space in the garage and recoup my investment.

I'm also doing smaller ~2 gallon BIAB batches inside to experiment and keep a bottle inventory over just legs.


Sent from my iPhone using Tapatalk