Page 1 of 1
WANTED: 3/4" to 1/2" Stainless Steel Reducing Coupling
Posted: Wed Sep 28, 2016 9:12 am
by Matt F
Anybody have one of these I could buy from you? Otherwise going to order soon to use on the new pump head I got from Andrew.
http://www.bargainfittings.com/index.ph ... uct_id=127
Re: WANTED: 3/4" to 1/2" Stainless Steel Reducing Coupling
Posted: Wed Sep 28, 2016 12:41 pm
by czubak
I have a couple you can have Matt. I even have a 3/4" fitting with a male camlock on the end for this very purpose. Camlocks, rule....you should switch to camlocks
When do you need the fitting by? I can get it to you tomorrow or Friday if you want to meet for lunch. Easier than after work with all the flooding BS.
Re: WANTED: 3/4" to 1/2" Stainless Steel Reducing Coupling
Posted: Wed Sep 28, 2016 2:38 pm
by Matt F
Thanks Chris. No way I am switching from my old reliable cheap plastic Kent QDs until I go full tri-clamp. Boil kettle is already there. Camlocks are nice though.